Howto do factory reset on HP ProCurve Switch by cli

Howto do factory reset on HP ProCurve Switch by cli

 

 

 

To do factory reset on CLI , you can run command “erase startup-config” and after that you can reboot.

HPSW#erase startup-config
HPSW#reload

After reboot , we can configure the new switch with default configuration.

HP J4903A ProCurve Switch 2824
Firmware revision I.08.58Copyright (C) 1991-2004 Hewlett-Packard Co. All Rights Reserved.RESTRICTED RIGHTS LEGENDUse, duplication, or disclosure by the Government is subject to restrictions
as set forth in subdivision (b) (3) (ii) of the Rights in Technical Data and
Computer Software clause at 52.227-7013.

HEWLETT-PACKARD COMPANY, 3000 Hanover St., Palo Alto, CA 94303

Username:

Password:

That’s all. Thanks for using IThelpblog.com.

Leave a reply

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>